350-101 Free Exam Questions & Answers (Updated 2026)

Question No 1

A school district is deploying Cisco Catalyst 9176 APs to remote sites with occasional WAN outages. The IT team wants the APs to attempt joining a secondary or tertiary Catalyst 9800 WLC if the primary controller is unreachable. The team must preconfigure all controller IP addresses using the AP CLI before deploying. Which set of CLI commands sets the primary, secondary, and tertiary controller IP addresses on a Catalyst 9176 AP?

Choose the Choices:

set controller primary -base main -wlc 10.10.10.10 set controller secondary -base backup 10.10.10.20 set controller tertiary -base tertiary -wlc 10.10.10.30

capwap ap primary -base main -wlc 10.10.10.10 capwap ap secondary -base backup -wlc 10.10.10.20 capwap ap tertiary -base tertiary -wlc 10.10.10.30

ap join primary 10.10.10.10 ap join secondary 10.10.10.20 ap join tertiary 10.10.10.30

capwap ap wlc primary 10.10.10.10 capwap ap wlc secondary 10.10.10.20 capwap ap wlc tertiary 10.10.10.30

Question No 2

Refer to the exhibit.

An engineer is setting up a new WLC in a branch office. The IT security policy states that all management access must use encrypted protocols, administrators will connect remotely, and network scans will be run to check for any noncompliant management protocol exposure. Which action must the engineer take to achieve the required management access policy?

Choose the Choices:

Permit only HTTP, Telnet, and SSH across all VLANs for 10.10.1.0/24.

Enable Telnet, SSH, and HTTPS across the management and guest interfaces.

Permit console access for 10.10.1.0/24 only with HTTP disabled.

Enable HTTPS and SSH, and disable HTTP and Telnet on the WLC.

Question No 3

How does the optimized roaming function operate in a WLC implementation?

Choose the Choices:

It disassociates clients when the RSSI is lower than the set threshold.

It is integrated with external services for client wireless experience.

Device locations are determined through peer -to-peer beacons.

Load balancing is statically defined for all locations.

Question No 4

A network engineer must isolate all guest users connected to the WLAN on a Cisco 9800 WLC so they cannot communicate with each other but can access the internet. The WLAN must meet these requirements • SSID named VisitorAccess assigned to VLAN 30 • guests prohibited from sharing files with other guests • must be scalable to multiple access points in the building Which action must the network engineer take to meet the requirements?

Choose the Choices:

Enable P2P blocking in the policy profile and map the WLAN to a dedicated guest VLAN.

Set up local authentication and map the WLAN to a dedicated guest VLAN.

Set up a FlexConnect group and use local switching for the guest WLAN internet access.

Enable multicast mode and associate a RADIUS server with the guest WLAN.

Question No 5

How does MIMO operate during wireless transmission?

Choose the Choices:

It uses multiple radio paths to increase throughput and reliability.

It applies frequency hopping to prevent crosstalk.

It shares a single connection among endpoints for coverage expansion.

It limits data paths to a single antenna for error reduction.

Cisco 350-101 Free Exam Questions (Updated 2026)

Question No 1

Question No 2

Question No 3

Question No 4

Question No 5

350-101 Exam Features

350-101 PDF Dumps