Pass 350-601 Exam Questions ~ 100% success in initial try

Question No 1

An engineer is implementing OTV on a transport that supports multicast. The solution needs to meet the following requirements: • Establish adjacency to the remote peer by using multicast. • Enable OTV advertisements for VLAN 100 to the other site. Which two commands should be configured to meet these requirements? (Choose two.)

Choose the Choices:

otv site-vlan 100

otv data-group 232.2.2.0/28

otv use-adjacency-server 172.27.255.94

otv extend-vlan 100

otv control-group 232.1.1.1

Question No 2

An engineer updated firmware on Fabric Interconnects and activates it. However, the endpoint fails to boot from the new firmware image. What is expected to occur in this case?

Choose the Choices:

The system defaults to the backup image version

The system defaults to and boots into GOLD firmware image

The system defaults to the GOLD firmware image

The system defaults to and boots into kickstart image

Question No 3

Which configuration statically assigns VSAN membership to a virtual Fibre Channel interface?

Choose the Choices:

Question No 4

An engineer must configure OSPF routing on Cisco Nexus 9000 Series Switches. The IP subnet of the Eth 1/2 interface for both switches must be advertised via OSP ,However, these interfaces must not establish OSPF adjacency or send routing updates. The current OSPF adjacency over the interface Eth1/1 on SW1 and Eth1/1 on SW2 must remain unaffected. Which configuration must be applied to both Nexus switches to meet these requirements?

Choose the Choices:

interface ethernet 1/2 passive-interface default

Interface ethernet 1/2 Ip ospf network point-to-point

interface ethernet 1/2 ip ospf passive-interface

interface ethernet 1/2 no ip ospf passive-Interface

Practice Cisco 350-601 Exam Questions

Question No 1

Question No 2

Question No 3

Question No 4

350-601 Exam Features

350-601 PDF Dumps