Decide Fast & Get 50% Flat Discount on This Special Offer | Limited Time Offer - Ends In COUPON CODE: SAVE50%

Dell EMC DES-5121 Free Exam Questions (Updated 2026)

    • PDF Questions

      • Exam Code: DES-5121
      • Exam Name: Specialist  Implementation Engineer, Campus Networking Version 1.0
      • Total Questions: 65
      • PDF Price: $29.50 / $59.00
    • Bundle Pack

      • Exam Code: DES-5121
      • Exam Name: Specialist  Implementation Engineer, Campus Networking Version 1.0
      • Total Questions: 65
      • Bundle Price: $49.50 / $99
    • Online Engine

      • Exam Code: DES-5121
      • Exam Name: Specialist  Implementation Engineer, Campus Networking Version 1.0
      • Total Questions: 65
      • Practice Test Price: $34.50 / $69.00
    1. Page: 1/13
      Total 65 Questions
    Question No 1
    If a VRRP Master router is rebooted, what is the default behavior once it comes back online?
    Choose the Choices:


    Question No 2
    If a group of routers are running VRRP with a virtual router ID of 155, which MAC address will be used to respond to the ARP requests for the virtual IP?
    Choose the Choices:


    Question No 3
    An administrator just finished configuring a Dell EMC N - Series switch. After rebooting the switch, the administrator notices that all the configuration settings just entered are gone. Which command did the administrator fail to enter?
    Choose the Choices:


    Question No 4
    When configuring a PBR route - map, what are the configurable "SET" options?
    Choose the Choices:


    Question No 5
    Switch - 1(config)# interface tengigabitethernet 1/0/1 Switch - 1(config)# switchport mode access Switch - 1(config)# switchport trunk allowed vlan 10, 20 Switch - 1(config)# Switch - 1(config)# interface tengigabitethernet 1/0/3 Switch - 1(config)# switchport mode access Switch - 1(config)# switchport access vlan 10 Switch - 2(config)# interface tengigabitethernet 1/0/2 Switch - 2(config)# switchport mode trunk Switch - 2(config)# switchport trunk allowed vlan 10, 20 Switch - 2(config)# Switch - 2(config)# interface tengigabitethernet 1/0/6 Switch - 2(config)# switchport mode access Switch - 2(config)# switchport access vlan 20 A network administrator is troubleshooting why Host 1 cannot communicate with Host 2. Based on the switch output shown in the exhibit, what is the reason for the communication issue?
    Choose the Choices:

    Next Question

    1. Page: 1/13
      Total 65 Questions