Pass FCSS_SDW_AR-7.4 Exam Questions ~ 100% success in initial try

Question No 1

Exhibit.

Two hub - and - spoke groups are connected through redundant site - to - site IPsec VPNs between Hub 1 and Hub 2 Which two configuration settings are required for the spoke A1 to establish an ADVPN shortcut with the spoke B2? (Choose two.)

Choose the Choices:

On hubs, auto - discovery - forwarder must be enabled on the IPsec VPNs to hubs.

On hubs, auto - discovery - receiver must be enabled on the IPsec VPNs to spokes.

On hubs, auto - discovery - forwarder must be enabled on the IPsec VPNs to spokes.

On hubs, auto - diacovery - sender must be enabled on the IPsec VPNs to spokes

Question No 2

Refer to the exhibit.

Which SD - WAN rule and interface uses FortiGate to steer the traffic from the LAN subnet 10.0.1.0/24 to the corporate server 10.2.5.254?

Choose the Choices:

SD - WAN service rule 3 and interface HUB1 - VPN2.

SD - WAN service rule 3 and interface HUB1 - VPN3.

SD - WAN service rule 4 and port1 or port2.

SD - WAN service rule 4 and interface port2.

Question No 3

Refer to the exhibit.

Refer to the exhibit. You want to configure SD - WAN on a network as shown in the exhibit. The network contains many FortiGate devices. Some are used as NGFW, and some are installed with extensions such as FortiSwitch. FortiAP. or Forti Ex tender. What should you consider when planning your deployment?

Choose the Choices:

You can build an SD - WAN topology that includes all devices. The hubs can be FortiGate devices with Forti Extender.

You can build an SD - WAN topology that includes all devices. The hubs must be devices without extensions.

You must use FortiManager to manage your SD - WAN topology.

You must build multiple SD - WAN topologies. Each topology must contain only one type of extension.

Question No 4

Refer to the exhibit.

Refer to the exhibit that shows event logs on FortiGate. Based on the output shown in the exhibit, what can you say about the tunnels on this device?

Choose the Choices:

The master tunnel HU82 - VPN3 cannot accept ADVPN shortcuts.

The device steers voice traffic through the VPN tunnel HUB1 - VPN3.

The VPN tunnel HUB1 - VPN1_0 is a shortcut tunnel.

There is one shortcut tunnel built from master tunnel VPN4.

Question No 5

Exhibit.

Which action will FortiGate take if it detects SD - WAN members as dead?

Choose the Choices:

FoftiGate bounces port5 after it detects all SD - WAN members as dead.

FortiGate fails over to the secondary device after it detects port5 as dead.

FortiGate sends alert messages through poft5 when it detects all SD - WAN members as dead

FortiGate brings down port5 after it detects all SD - WAN members as dead.

Practice Fortinet FCSS_SDW_AR-7.4 Exam Questions

Question No 1

Question No 2

Question No 3

Question No 4

Question No 5

FCSS_SDW_AR-7.4 Exam Features

FCSS_SDW_AR-7.4 PDF Dumps