Decide Fast & Get 50% Flat Discount on This SUMMER SPECIAL OFFER | Limited Time Offer - Ends In COUPON CODE: SUM50

Practice HP HPE2-W09 Exam Questions

    1. Page: 1/26
      Total 129 Questions
    Question No 1
    Refer to the exhibit. Switch-1 and Switch-2 ate ArubaOS-CX switches that implement VXLAN WITHOUT Ethernet VPN (EVPN). Switch-2 uses the same VNI-to-VLAN mappings as Switch-1. Is this how the specified servers communicate? Solution: The first time that Server I communicates with Server 3, It sends an ARP request to resolve Server 3's MAC address.
    Choose the Choices:


    Question No 2
    You want to use NetEdit to configure an AtubaOS-CX switch. Is this a minimum requirement for setting up communications between the switch and NetEdit? Solution: Enable the REST interface in read-only mode.  
    Choose the Choices:


    Question No 3
    You want to use NetEdit to configure an AtubaOS-CX switch. Is this a minimum requirement for setting up communications between the switch and NetEdit? Solution: Make sure that the SSH server is enabled.
    Choose the Choices:


    Question No 4
    Is this a guideline for establishing a Virtual Switching Extension (V5X) Inter-Switch Link (ISL) between two ArubaOS-CX switches? Solution: Use the same speed on every link In the ISL.
    Choose the Choices:


    Question No 5
      Refer to the exhibit. Refer to the exhibit.   You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF , Is this part of a valid setup for meeting these requirements?Solution: Add VRF B as the secondary VRF on VLAN interface 30.
    Choose the Choices:



    1. Page: 1/26
      Total 129 Questions