Pass HPE6-A69 Exam Questions ~ 100% success in initial try

Question No 1

Refer to the exhibit.

Aruba CX 6300 switch has routes in three different VRFs as per the example above. The user needs to leak routes between VRF Secure and VRF Dev. and also between VRF default and VRF Dev The customer Is not able to establish routing between directly connected networks 10.100.50.0/24 and 10.102.26.0/24 Which statement is true regarding the routing troubleshooting?

Choose the Choices:

Multi - protocol BGP routing needs to be defined for route leaking

Route Distinguisher needs to be set to 1 for default VRF.

Route leaking is supported between non - default VRFs only

Route leaking between default and non - default VRFs is supported with Aruba CX 8400.

Question No 2

Choose the Choices:

The ArubaOS - CX switch requires plain - text authentication with OSPF.

The third - party switch should be configured with MD5 authentication

The ArubaOS - CX switch does not expect authentication with OSPF.

The third - party switch should be configured with key chain authentication

Question No 3

When applying me following access - Iist to an ArubaOS - CX 6300 switch:

How does this ACL behave on the selected switch? (Select two.)

Choose the Choices:

The mp traffic to MANAGEMENT - SERVERS group is logged to me event logs

The tftp traffic to MANAGEMENT - SERVERS group is not logged to the event logs.

The snmp - trap traffic to MANAGEMENT - SERVERS is logged to the event togs.

The denied tcp traffic to the MANAGEMENT - SERVERS group is logged to event logs.

The denied tcp traffic to the MANAGEMENT - SERVERS group is not logged to event logs

Question No 4

The customer is considering Implemented the following VSX configuration that will host an Aruba mobility cluster servicing 9000 dual stack employee devices. The client's default gateways will be hosted on the VSX stack. The customer is seeking advice about how to ensure ArubaOS - CX VSX best practices have been applied. What advice can you offer the customer? (Select two)

Choose the Choices:

The ISL Bandwidth should be upgraded

Agg - 1 and Agg - 2's hardware forwarding table profile should be changed to "L3 - agg''.

The - system - mac' of Agg - 1 should be changed to an unused address from the unicast private address range

The vsx linkup - delay timer is unnecessarily high; it should be reduced to prevent excessive delay of packet forwarding when a VSX peer joins an existing master.

The Keepalive interface should be changed to interface LAG2 so there is redundancy through the mobility cluster.

The keepalive subnet is misconfigured, it has an inappropriate address on Agg - 1.

Question No 5

(Scenarios may contain multiple errors which may or may not Impact the solution > Refer to the exhibit.

An engineer has attempted to configure two pairs of switches in the referenced configuration it is required to implement VSX keep - alive at the aggregation layer. The ports of the ArubaOS - CS 8325 switches used for Agg01 and Agg02 are populated as follows:

The configuration of switch AGG01 includes:

VSX keep - alive is not working. Which modification should you make lo resolve the error condition?

Choose the Choices:

Edit interface 1/1/48, adding the command "vpn - instance KA"

Modify the Interface lag 2 command, removing "multi - chassis"

Modify the Keepalive peer 192.168.20.2 source 192 168.20.1 command, adding "vrf KA"

Edit the vsx - sync command, adding "keep - alive"

Practice HP HPE6-A69 Exam Questions

Question No 1

Question No 2

Question No 3

Question No 4

Question No 5

HPE6-A69 Exam Features

HPE6-A69 PDF Dumps