Pass JN0-650 Exam Questions ~ 100% success in initial try

Question No 1

Exhibit.

You want to limit port access to only one device at a time. Referring to the exhibit, which configuration change will accomplish this task?

Choose the Choices:

Question No 2

Your OSPF network consists of a mix of 1GbE and 10GbE interfaces. By default, all interfaces have the same cost in your OSPF network. You are asked to ensure that the 10GbE interfaces are more preferred when available In this scenario, which two statements would accomplish this behavior? (Choose two.)

Choose the Choices:

You should define the reference bandwidth as 10G. which will assign the 1GbE interfaces a higher cost

You should manually assign the interface metric for each 10GbE interface to be higher than the 1GbE interfaces in your OSPF network.

You should define the reference bandwidth as 1G. which will assign the 1GbE interfaces a higher cost.

You should manually assign the interface metric for each 1GbE interface to be higher than the 10GbE interfaces in your OSPF network.

Question No 3

You have two multicast receivers connected to the same VLAN. You notice that the switch that they are connected to is forwarding multicast traffic out of all the ports in the same VLAN, instead of just the two ports for the connected multicast receivers In this scenario, what would you configure to optimize multicast forwarding?

Choose the Choices:

Question No 4

You are implementing an EVPN - VXLAN edge - routed bridging design using Layer 3 gateway operations. In this scenario, which statement is correct?

Choose the Choices:

Each distribution switch has unique IP addresses for IRB interfaces; routing protocols run on IRB interfaces

Distribution switches share the same anycast IP addresses for IRB interfaces; routing occurs at the distribution layer.

Only core switches have IRB interfaces; all Layer 3 routing happens in the core.

IRB interfaces are disabled; all routing happens through external routers only.

Question No 5

Which statement about LLDP and LLDP - MED operations on EX Series devices is correct?

Choose the Choices:

LLDP only operates on interfaces configured for Layer 2

EX Series devices flood LLDP frames across a Layer 2 domain to calculate a network topology

EX Series devices support LLDP - MED power negotiation, enabling dynamic allocation of PoE power based on endpoint device needs.

LLDP - MED focuses on discovering network connectivity devices like routers and switches.

Practice Juniper JN0-650 Exam Questions

Question No 1

Question No 2

Question No 3

Question No 4

Question No 5

JN0-650 Exam Features

JN0-650 PDF Dumps